Bendix coils

For pre 1975 outboards and race motors only.

Moderators: Alacrity, Rapier

Post Reply
rogerfishburn
Posts: 1044
Joined: Sat Jul 21, 2012 5:59 pm
CMBA Member: 0

Bendix coils

Post by rogerfishburn »

Hello chaps, I have a couple of Anzani 400's and a Perkins 40 that i would like to restore so I wondered if anyone knew if there was somewhere I could source NOS Bendix coils or if anyone out there could refurbish mine. Any advice would be gratefully received apart from telling me to scrap them of course. Many thanks for taking the time to read this
Cheers Roger

User avatar
Rapier
Site Admin
Posts: 11551
Joined: Thu Feb 05, 2009 5:16 pm
CMBA Member: 569
Location: West Glos

Re: Bendix coils

Post by Rapier »

Do you know what the model numbers are? I seem to remember they're externally mounted, rather than under flywheel? Are the same as the Oliver 35hp?
Fasten bra straps and remove dentures...

rogerfishburn
Posts: 1044
Joined: Sat Jul 21, 2012 5:59 pm
CMBA Member: 0

Re: Bendix coils

Post by rogerfishburn »

I will try and get sdome photos tomottow , also have an 18 hp anzani to sort and a perkins 30

Cranky
Posts: 1
Joined: Sat Nov 14, 2020 3:43 pm
CMBA Member: 0

Re: Bendix coils

Post by Cranky »

There is a coil available to substitute the discontinued Bendix coil.
It is identical to the Bendix coil except for the location of the spark
plug wire connection. Instead of being located on the top (or bottom)
its offset 22.5 degrees to one side. I'm going to try to attach an eBay
link. I'm new here. Hope it works.

https://www.ebay.com/itm/NEW-Andover-Co ... 3716294835

Post Reply