Doing the same here, have a look at Navigattos and General who have an on line third party only offer at about £80

another suggestion:
First - get any grease off with a chemical degreasing agent, then use Mordant solution (available from a commercial paint/decorator supplier). This turns the galvanised surface black and etched clean ready for primer etc. Use good quality products.
Worked for me on some mudguards.

Anybody interested - postage only wanted.
About 10 years old but as new.

For what it's worth about 40 years ago I had a Snipe trailer with the said springs. The bearing was held on by a circlip. Driving down the A1 one day I saw a wheel coming past me. The wheel was mine, had hit something and bounced the circlip off leaving the bearing free to pop off at the next opport...

Hello,
Surplus to requirements, red lens is almost complete, green not there (i was planning to make a copy).
The base of the fixing recess has gone but I've made a collar which works.
No reasonable offer refused.
Crowthorne

I'm trying to send you PMs.
Are you receiving them?
If not please PM and I'll try to respond.
Thanks

There's a complete engine on eBay at the moment if you are interested.
VINTAGE FORD MARK 2 ZEPHYR SIX ENGINE-EX MOD GEN-SET USE-SUIT RESTORER
( 272109825711 )

Anybody happen to know where I might be able to get a replacement switch or even the actuator rocker?
The hole size seems to be 2 inches by 7/8 inches.
Many modern switches are correct width but much shorter.
Rating 12 volts and a few amps.
Thanks

In an attempt to make life a little easier I bought some "calibrated" measuring cups. After suffering some variability of results I checked the measuring cups and found that the ratio measurements are way off. For example using the 2:1 and starting with about 320 ml, the extra "1" added only about 1...

OK, let's see if this works.
Low res images on Flickr.
PM me if you want high res versions

http://www.flickr.com/photos/100924614@N05/